This board contains the ENTIRE Alphabet A-Z plus numbers 0-9. (Etched over both sides)

These letters and numbers are the perfect addition to any cookie theme, by adding a small custom detail! Also perfect for adding accents to cakes and small enough for cupcake toppers!

There is enough room around the Numbers and Letters to cut up to a 63mm round.

Shown in the Sarah Maddison cake stamp and cutter and the large wavy round cutter.

Entire board made from non stick acrylic 28cm x 16cm and the the cutter is made from PLA+ and is 40mm round.

Pattern Plates make perfect backgrounds for this patch! See our range of pattern plates here.

Orders from America and England have our products made in those countries and sent direct to you so no long waits on international shipping or taxes. Product in those countries will come as two boards. (not back to back)

How to Use Your 3D Raised Debosser

1. With the etched side up, lightly dust pre-rolled fondant with cornflour and place it over your debosser. Using a rolling pin, roll the fondant over the top in one smooth motion. This will push the fondant into the design, leaving it perfectly raised.
2. Gently peel the fondant away and place it on your bench. Use a cookie cutter to cut around the design. Lightly brush your cookie with water, then carefully transfer the cut fondant to your cookie.
3. Now that your cookie is looking amazing, you can easily paint or decorate the raised design. It's as easy as that!

DO NOT wash in dishwasher / Hand wash only, keep below 50 degrees/c (122 degrees/f)

*All designs are Copyright protected and can not be copied. Designs have been hand drawn by Sarah Maddison Creative and Custom Cookie Cutters are the exclusive manufacture worldwide.

Letter and Number Debosser Plate and Cutter (Sarah Maddison Creative)